User's Manual
Table Of Contents
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- CONFIGURATION GUIDE
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING GXP1760/GXP1780/GXP1782
P a g e | 49
GXP17xx Administration Guide
Layer 2 QoS 802.1p
Priority Value
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
PC Port Mode
Configures the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enabled".
PC Port VLAN Tag
Assigns the VLAN Tag of the PC port. The default value is “0”.
PC Port Priority Value
Assigns the priority value of the PC port. The default value is “0”.
Enable LLDP
Control the LLDP (Link Layer Discovery Protocol) service. The default setting
is “Enabled”.
Maintenance Page Definitions
Table 9: Maintenance Page Definitions
Maintenance Web Access
User Password
Set new password for web GUI access as User. This field is case sensitive.
Confirm Password
Enter the new User password again to confirm.
Current Admin
Password
The current admin password is required for setting a new admin password.
New Password
Set new password for web GUI access as Admin. This field is case
sensitive.
Confirm Password
Enter the new Admin password again to confirm.
Maintenance Upgrade and Provisioning
Firmware Upgrade and
Provisioning
Specifies how firmware upgrading and provisioning request to be sent:
Always Check for New Firmware, Check New Firmware only when F/W
pre/suffix changes, Always Skip the Firmware Check. The default setting is
“Always Check for New Firmware”.
XML Config File
Password
The password for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration
file.
HTTP/HTTPS User
Name
The user name for the HTTP/HTTPS server.
HTTP/HTTPS
Password
The password for the HTTP/HTTPS server.
Always Authenticate
Before Challenge
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials
before being challenged by the server. The default setting is “No”.
Upgrade Via
Allows users to choose the firmware upgrade method: TFTP, HTTP or
HTTPS. The default setting is “HTTP”.