User's Manual

P a g e | 34
GXP17xx Administration Guide
Click-To-Dial Feature
Enables Click-To-Dial feature. If this feature is enabled, user could click
the green dial button on left top corner of phone’s Web GUI, then choose
the account and dial to the target number. The default setting is
"Disabled".
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
0 means this option is disabled. The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. 0
means this option is disabled. The default value is 200 entries.
Default call log type
This option is used for users to set the default call log list after select
MENUCALL HISTORY. Broadsoft Call Log or Local Call Log option will
only show its own list. Default option will keep both call log lists.
Local Call Recording
Feature
Enables/Disables the ability to record calls locally while on the call
screen. The default setting is "Disabled".
Saved Local Call Recording
Location
This option is used for users to set the location where the recordings will
be stored.
Download Local Call
Recordings
When there are recordings presented, you may download them here.
Settings  Multicast paging
Paging Barge
During active call if incoming multicast page is higher priority (1 being the
highest) than this value the call will be held and multicast page will be
played. The default setting is “Disabled”.
Paging Priority Active
If enabled, during a multicast page if another multicast is received with
higher priority (1 being the highest) that one will be played instead. The
default setting is “Disabled”.
Multicast Paging Codec
The codec for sending multicast pages, there are 5 codecs could be
used: PCMU, PCMA, G.726-32, G.729A/B, G.722 (wide band). The
default setting is “PCMU”.
Multicast Listening
Defines multicast listening addresses and labels. For example:
“Listening Address” should match the sender’s Value such as
“237.11.10.11:6767”
“Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our
Website.
Settings  Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.