User's Manual

P a g e | 33
GXP17xx Administration Guide
setting is "No".
Off-hook Timeout
If configured, when the phone is on hook, it will go off hook after the
timeout (in seconds). The default value is 30 seconds. The valid range is
from 10 to 60.
Bypass Dial Plan Through
Call History and Directories
Enable/Disable the dial plan check while dialing through the call history
and any phonebook directories. The default setting is “No”.
Disable Call Waiting
Disables the call waiting feature. The default setting is "No".
Disable Call Waiting Tone
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disable Busy Tone on
Remote Disconnect
Disable the busy tone heard in the handset when call is disconnected
remotely. The default setting is “No”.
Disable Direct IP Call
Disables Direct IP Call. The default setting is "No".
Use Quick IP Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference
Disables the Conference function. The default setting is "No".
Disable in-call DTMF Display
When it's set to "Yes", the DTMF digits entered during the call will not be
displayed on phone LCD. The default setting is "No".
Enable sending DTMF via
specific MPKs
Enables certain MPKs to send DTMF during the call. This option does
not affect Dial DTMF. The default setting is "No".
Disable Active MPK Page
When option is enabled, Active MPK Page on the extension boards will
be disabled. The default setting is "No".
Mute Key Functions While
Idle
Specifies the function of mute key in idle. Default setting is “DND”. When
select “Idle Mute” and press Mute key while idle, the future incoming call
will be answered with mute. When select “Disabled”, Mute key will not
take effect while idle. The default setting is “No”.
Disable Transfer
Disables the Transfer function. The default setting is "No".
In-call dial number on
pressing transfer key
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".