User's Manual

P a g e | 22
GXP17xx Administration Guide
BLF Server
Configures the optional server used for SUBSCRIBE requests to indicate
other extensions status on the SIP server.
SIP User ID
Configures user account information provided by your VoIP service provider
(ITSP). It's usually in the form of digits similar to phone number or actually a
phone number.
Authenticate ID
Configures the SIP service subscriber's Authenticate ID used for
authentication. It can be identical to or different from the SIP User ID.
Authenticate Password
Configures the account password required for the phone to authenticate with
the ITSP (SIP) server before the account can be registered. After it is saved,
this will appear as hidden for security purpose.
Name
Specifies SIP server subscriber's name (optional) that will be used for Caller
ID display.
Voice Mail User ID
Sets if the phone system allows users to access the voice messages by
pressing the MESSAGE key on the phone. This ID is usually the VM portal
access number. For example, in UCM6100 IPPBX, *97 could be used.
Show Account Name
Only
Enables to display the account name; if it is checked, the user ID will be
hidden and the account name will be displayed only.
Account x  Network Settings
DNS Mode
Defines which parameter will control how the Search Appliance looks up IP
addresses for hostnames. There are four modes: A Record, SRV,
NATPTR/SRV, Use Configured IP. The default setting is "A Record". If the
user wishes to locate the server by DNS SRV, the user may select "SRV" or
"NATPTR/SRV".
If "Use Configured IP" is selected, please fill in the three fields below:
 Primary IP:
 Backup IP 1;
 Backup IP 2.
If SIP server is configured as domain name, phone will not send DNS query,
but use “Primary IP” or “Backup IP x” to send SIP message if at least one of
them are not empty. Phone will try to use “Primary IP” first. After 3 tries
without any response, it will switch to “Backup IP x”, and then it will switch
back to “Primary IP” after 3 re-tries.
If SIP server is already an IP address, phone will use it directly even “User
Configured IP” is selected.
NAT Traversal
Specifies which NAT traversal mechanism will be enabled on the phone
system. Users could select the mechanism from No, STUN, Keep-alive,
UPnP, Auto or VPN. The default setting is "No".
If set to "STUN" and STUN server is configured, the phone will route