User's Manual
Table Of Contents
- User manual.pdf
- User manual.pdf
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- CONFIGURATION GUIDE
- Configuration via Keypad
- Configuration via Web Browser
- Definitions
- Connecting the GXP1760W to WiFi
- NAT Settings
- Editing Contacts and Click-To-Dial
- Saving Configuration Changes
- Rebooting from Remote Locations
- Packet Capture
- Multicast Paging
- Configuring Eventlist BLF
- Configuring VPK Keys
- Outbound Notification Support
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING THE GXP1760W
- User manual.pdf
- FCC 普通产品
GXP1760W Administration Guide
P a g e | 54
Figure 5: Click-to-Dial
Saving Configuration Changes
After users makes changes to the configuration, press the "Save" button will save but not apply the changes
until the "Apply" button on the top of web GUI page is clicked. Or, users could directly press "Save and
Apply" button. We recommend rebooting or powering cycle the phone after applying all the changes.
Rebooting from Remote Locations
Press the "Reboot" button on the top right corner of the web GUI page to reboot the phone remotely. The
web browser will then display a reboot message. Wait for about 1 minute to log in again.
Packet Capture
GXP1760W is embedded with packet capture function on firmware 1.0.0.38 or greater. The related options
are under Maintenance Packet Capture.
Figure 6: Packet Capture in Idle
Users need to choose first the capture location either the internal storage or the connected USB and then
press Start button to start packet capture. Press Stop to end capture.
User can press Download button to download capture file to local PC.