User's Manual
Table Of Contents
- User manual.pdf
- User manual.pdf
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- CONFIGURATION GUIDE
- Configuration via Keypad
- Configuration via Web Browser
- Definitions
- Connecting the GXP1760W to WiFi
- NAT Settings
- Editing Contacts and Click-To-Dial
- Saving Configuration Changes
- Rebooting from Remote Locations
- Packet Capture
- Multicast Paging
- Configuring Eventlist BLF
- Configuring VPK Keys
- Outbound Notification Support
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING THE GXP1760W
- User manual.pdf
- FCC 普通产品
GXP1760W Administration Guide
P a g e | 44
Address
OpenVPN® Port
Specifies the listening port of the OpenVPN® server. Default is 1194.
OpenVPN®
Transport
Specifies the Transport Type of OpenVPN® whether UDP or TCP. Default is
UDP.
OpenVPN® CA
Uploads the Certification Authority of OpenVPN®. For a new upload, users could
click on “Delete” to erase the last certificate, and then upload a new one.
OpenVPN®
Certificate
Click on “Upload” to upload OpenVPN® certificate. For a new upload, users
could click on “Delete” to erase the last certificate, and then upload a new one.
OpenVPN® Client
Key
Click on “Upload” to upload OpenVPN® Key. For a new upload, users could click
on “Delete” to erase the last certificate, and then upload a new one.
Network WiFi Settings
Enable/Disable WiFi
Enables / Disables the WiFi on the phone. Default setting is “No”.
Access Point (1 - 10)
SSID
Enters WiFi SSID name to connect.
Password
Configures the authentication password to access WiFi
Network.
Security Type
Specifies the WiFi encryption type. The available options are
the following: None, WEP, WPA, WPA Enterprise and Auto.
Default settings is None.
Maintenance Page Definitions
Table 8: Maintenance Page Definitions
Maintenance Web Access
New Password
Set new password for web GUI access as User. This field is case sensitive.
Confirm Password
Enter the new User password again to confirm.
Current Password
The current admin password is required for setting a new admin password.
New Password
Set new password for web GUI access as Admin.
This field is case sensitive.
Confirm Password
Enter the new Admin password again to confirm.
Maintenance Upgrade and Provisioning
Upgrade Firmware
Allows users to upload the firmware file locally by pressing Start button, after
selecting the correct firmware file from the local storage, the phone will start
the firmware upgrade automatically.
Firmware Upgrade
and Provisioning
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check. The default setting is “Always
Check for New Firmware”.
Always Authenticate
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials