User's Manual
Table Of Contents
- User manual.pdf
- User manual.pdf
- CHANGE LOG
- GUI INTERFACE EXAMPLES
- WELCOME
- PRODUCT OVERVIEW
- CONFIGURATION GUIDE
- Configuration via Keypad
- Configuration via Web Browser
- Definitions
- Connecting the GXP1760W to WiFi
- NAT Settings
- Editing Contacts and Click-To-Dial
- Saving Configuration Changes
- Rebooting from Remote Locations
- Packet Capture
- Multicast Paging
- Configuring Eventlist BLF
- Configuring VPK Keys
- Outbound Notification Support
- UPGRADING AND PROVISIONING
- RESTORE FACTORY DEFAULT SETTINGS
- EXPERIENCING THE GXP1760W
- User manual.pdf
- FCC 普通产品
GXP1760W Administration Guide
P a g e | 34
• Message Waiting
• Ring Back Tone
• Call-Waiting Tone
• Busy Tone
• Reorder Tone
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence.
To set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a
pause of OFF ms and then repeat the pattern. Up to three cadences are
supported.
Call Waiting Tone
Gain
This adjusts the call waiting tone volume.
Users can select “Low”, “Medium” or “High”. The default setting is “Low”.
Speaker Ring
Volume
Configures speaker ring volume. Valid range is 0 to 7.
Settings Audio Control
Headset Key Mode
When headset is connected to the phone, users could use the HEADSET button
in "Default Mode" or "Toggle Headset/Speaker".
• Default Mode:
➢ When the phone is in idle, press HEADSET button to off hook the phone
and make calls by using headset. Headset icon will display on the screen
in dialing/talking status.
➢ When there is an incoming call, press HEADSET button to pick up the call
using headset.
➢ When there is an active call using headset, press HEADSET button to
hang up the call.
➢ When Speaker/Handset is being used in dialing/talking status, press
HEADSET button to switch to headset. Press it again to hang up the call.
Or press speaker/Handset to switch back to the previous mode.
• Toggle Headset/Speaker:
➢ When the phone is in idle, press HEADSET button to switch to Headset
mode. The headset icon will display on the left side of the screen. In this
mode, if pressing Speaker button or Line key to off hook the phone,
headset will be used.
➢ When there is an active call, press HEADSET button to toggle between
Headset and Speaker.
Headset Type
Selects whether the connected headset is normal RJ11 headset, or Plantronics
EHS headset.
Always Ring
Speaker
Configures to enable or disable the speaker to ring when headset is used on
"Toggle Headset/Speaker" mode.
If set to "Yes", when the phone is in Headset "Toggle Headset/Speaker" mode,
both headset and speaker will ring on incoming call.
The default setting is "No".
Headset TX gain
Configures the transmission gain of the headset. The default value is 0dB.