User's Manual

GXP1760W Administration Guide
P a g e | 33
Return Code When
Refusing Incoming
Call
Send selected type of SIP message to the call when refusing the incoming call.
Return Code When
Enable DND
Send selected type of SIP message when enabling DND.
Local Call
Recording Feature
Enables/Disables the ability to record calls locally while on the call screen. The
default setting is "Disabled"
Saved Local Call
Recording Location
Defines the location where the recordings will be stored, either on the internal
storage or on the connected USB. Default setting is “Internal Storage”
Download Local Call
Recordings
Allows users to download the available local call recording.
User-Agent Prefix
Configure the prefix in the “User-Agent” header.
Predictive Dialing
Feature
Enables/Disables predictive dialing feature.
While dialing, the phone will predict and list candidates of the target number based
on the entered digits. If the target number exists in the phonebook/call history, the
phone will display a list of matched numbers and the user could select the number
using the Up/Down key and dial out.
The default setting is “Enabled”.
Settings  Multicast paging
Paging Barge
During active call if incoming multicast page is higher priority (1 being the highest)
than this value the call will be held and multicast page will be played. The default
setting is “Disabled”.
Paging Priority
Active
If enabled, during a multicast page if another multicast is received with higher
priority (1 being the highest) that one will be played instead. The default setting is
“Disabled”.
Multicast Paging
Codec
The codec for sending multicast pages, there are 5 codecs could be used: PCMU,
PCMA, G.726-32, G.729A/B, G.722 (wide band), G.723 and iLBC. The default
setting is “PCMU”.
Multicast Listening
Defines multicast listening addresses and labels. For example:
“Listening Address” should match the sender’s Value such as
“237.11.10.11:6767”
“Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our Website.
Settings  Ring Tone
Call Progress
Tones:
• System Ring Tone
• Dial Tone
• Second Dial Tone
Configures ring or tone frequencies based on parameters from local telecom. The
default value is North American standard. Frequencies should be configured with
known values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]].