User's Manual

GXP1760W Administration Guide
P a g e | 32
Disable Busy Tone
on Remote
Disconnect
Disable the busy tone heard in the handset when call is disconnected remotely.
The default setting is “No”.
Disable Direct IP
Call
Disables Direct IP Call. The default setting is "No".
Use Quick IP Call
mode
When set to "Yes", users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address. To dial quick IP call, off hook
the phone and dial #XXX (X is 0-9 and XXX <=255), phone will make direct IP call
to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address
REGARDLESS of subnet mask. #XX or #X are also valid so leading 0 is not
required (but OK). No SIP server is required to make quick IP call.
The default setting is "No".
Disable Conference
Disables the Conference function. The default setting is "No".
Disable in-call DTMF
Display
When it's set to "Yes", the DTMF digits entered during the call will not be displayed
on phone LCD. The default setting is "No".
Mute Key Functions
While Idle
Specifies the function of mute key in idle. Default setting is “DND”. When select
“Idle Mute” and press Mute key while idle, the future incoming call will be answered
with mute. When select “Disabled”, Mute key will not take effect while idle. The
default setting is “No”.
Disable Transfer
Disables the Transfer function. The default setting is "No".
In-call dial number
on pressing transfer
key
Configures the number for the phone to dial as DTMF during the call using TRAN
button.
Auto-Attended
Transfer
If set to "Yes", the phone will use attended transfer by default. The default setting
is "No".
Do Not Escape #
as %23 in SIP URI
Specifies whether to replace # by %23 or not for some special situations. The
default setting is "No".
Click-To-Dial
Feature
Enables Click-To-Dial feature. If this feature is enabled, user could click the green
dial button on left top corner of phone’s Web GUI, then choose the account and
dial to the target number. The default setting is "Disabled".
Call History Flash
Writing: Write
Timeout
Defines the interval (in seconds) to save the call history to phone's flash. 0
means this option is disabled. The default value is 300 seconds.
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. 0 means
this option is disabled. The default value is 200 entries.
Default call log type
This option is used for users to set the default call log list after select
MENUCALL HISTORY. Broadsoft Call Log or Local Call Log option will only
show its own list.
Default option will keep both call log lists.