User's Manual

GXP1760W Administration Guide
P a g e | 30
Selects the distinctive ring tone for the matching rule. When the incoming caller
ID or Alert Info matches the rule, the phone will ring with the selected ring.
Ring Timeout
Defines the timeout (in seconds) for the rings on no answer. The default setting
is 60. The valid range is from 10 to 300.
Send Anonymous
If set to "Yes", the "From" header in outgoing INVITE messages will be set to
anonymous, essentially blocking the Caller ID to be displayed.
The default setting is "No".
Anonymous Call
Rejection
If set to "Yes", anonymous calls will be rejected.
The default setting is "No".
Auto Answer
If set to "Yes", the phone will automatically turn on the speaker phone to answer
incoming calls after a short reminding beep. Default setting is “No”.
Allow Auto Answer
by Call-Info
If set to "Yes", the phone will automatically turn on the speaker phone to answer
incoming calls, based on the SIP info header sent from the server/proxy. The
default setting is "No".
Custom Call-Info for
Auto Answer
Used in addition to match the contents of the info parameter in the Call-Info
header for auto answer.
Refer-To Use Target
Contact
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
Transfer on
Conference Hang-
up
If set to "Yes", when the phone hangs up as the conference initiator, the
conference call will be transferred to the other parties so that other parties will
remain in the conference call. The default setting is "No".
Disable Recovery
on Blind Transfer
Disable recovery to the call to the transferee on failing blind transfer to the
target. The default setting is “No”.
No Key Entry
Timeout (s)
Defines the timeout (in seconds) for no key entry. If no key is pressed after the
timeout, the digits will be sent out. The default value is 4 seconds. The valid
range is from 1 to 15.
Use # as Dial Key
Allows users to configure the "#" key as the "Send" key. If set to "Yes", the "#"
key will immediately dial out the input digits. In this case, this key is essentially
equivalent to the "Send" key. If set to "No", the "#" key is included as part of the
dialing string and please make sure the dial plan is properly configured to allow
dialing # out. The default setting is “Yes”.
Account x  Feature Codes
Enable Local Call
Features
When enabled, Do Not Disturb, Call Forwarding and other call features can be
used via the local feature codes on the phone. Otherwise, the provisioned
feature codes from the server will be used. User configured feature codes will
be used only if server provisioned feature codes are not provided. And once
feature codes are configured, either via server provisioning or local setting, a
softkey named “Features” will show on the LCD screen.