User's Manual

FIRMWARE VERSION 1.0.5.2 GXP1160/GXP1165 USER MANUAL Page 37 of 59
with selected distinctive ringtone. Matching rules:
 Specific caller ID number. For example, 8321123;
 A defined pattern with certain length using x and + to specify, where
x could be any digit from 0 to 9. Samples:
xx+ : at least 2-digit number;
xx : only 2-digit number;
[345]xx: 3-digit number with the leading digit of 3, 4 or 5;
[6-9]xx: 3-digit number with the leading digit from 6 to 9.
 Alert Info text
Users could configure the matching rule as certain text (e.g., priority)
and select the custom ring tone mapped to it. The custom ring tone
will be used if the phone receives SIP INVITE with Alert-Info header
in the following format:
Alert-Info: <http://127.0.0.1>; info=priority
Distinctive Ringtones
Selects the distinctive ring tone for the matching rule. When the
incoming caller ID or Alert Info matches the rule, the phone will ring with
the selected ring.
Ring Timeout
Defines the timeout (in seconds) for the rings on no answer. The default
setting is 60 seconds.
Send Anonymous
If set to "Yes", the "From" header in outgoing INVITE messages will be
set to anonymous, essentially blocking the Caller ID to be displayed.
Anonymous Call Rejection
If set to "Yes", anonymous calls will be rejected. The default setting is
"No".
Auto Answer
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep.
Allow Auto Answer by Call-Info
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep, based on the SIP
info header sent from the server/proxy. The default setting is "No".
Refer-To Use Target Contact
If set to "Yes", the "Refer-To" header uses the transferred target's
Contact header information for attended transfer. The default setting is
"No".
Transfer on Conference
Hangup
Defines whether or not the call is transferred to the other party if the
initiator of the conference hangs up. The default setting is "No".
Check SIP User ID for
incoming INVITE
If set to "Yes", SIP User ID will be checked in the Request URI of the
incoming INVITE. If it doesn't match the phone's SIP User ID, the call will
be rejected. The default setting is "No".
Authenticate Incoming INVITE
Defines whether the phone will challenge INVITE requests or not. When
set to "Yes", the phone will challenge the INVITE for authentication with