User's Manual

GWN7000 Enterprise Router & Access Point Manager
User Manual
VPN
OVERVIEW
Only VPN client, No Server ?
VPN allows the GWN7000 to be connected to a remote VPN server using PPTP, L2TP and OpenVPN
protocols, users can access VPN page from the GWN7000 Web GUI -> VPN.
• To add a VPN tunnel users need to click on
• To edit a VPN tunnel users need to click on
• To delete a VPN tunnel users need to click on
Refer to the below tables depending on which VPN type has been selected.
1.1.1.4 OpenVPN
Table 12: OpenVPN
Enabled
If checked the VPN tunnel will be enabled.
VPN Name
Set the VPN’s name.
Zone
Set the Zone that will be using the VPN tunnel.
NAT Enable
If checked NAT will be enabled.
Port Forwarding Rules
Port Trigger Rules
OpenVPN Mode
Local Host
Set the local host IP address. Default is 0.0.0.0
Remote OpenVPN Server:Port
Set the remote OpenVPN server’s IP/FQDN and its port.
Protocol
Select UDP or TCP for protocol.
Device Type
Select TUN or TAP for the virtual network kernel device.
Allow Peer to Change IP
If checked, a device using the tunnel will still take control of the session if
its IP changes.
LZO Compression
Select Adaptive, Yes or No for LZO compression speed.
Fragment
Set the fragment value.
Mssfix
Set Mssfix value. Default is 1450.
Inactive Timeout
Set the inactivity timeout value (in unit) for restarting the connection.
CA Certificate
Click on to upload CA certificate.
Page | 37