User Guide

GRP26XX Administration Guide
P a g e | 50
Feature
not see any predictive numbers while dialing a number.
Predictive Dialing
Source
Predictive dialing feature will sequentially search the number based on the
selected sources from these: Call History, Local Phonebook, Remote
Phonebook, Feature Code.
Onhook Dial Barging
When disabled, on-hook dialing won’t be interrupted by an incoming call.
Default setting is Disabled.
Off-hook Auto Dial
Configures a User ID/extension to dial automatically when the phone is off
hook. The phone will use the first account to dial out. Default setting is “No”.
Off-hook Auto Delay
Configures the number of seconds during which the phone will wait before
dialing out when off-hood auto dial number is configured. The default is 0.
Off-hook Timeout
If configured, when the phone is off hook, it will go on hook after the timeout
(in seconds). The default value is 30 seconds. Valid range is from 10 to 60.
Enable Live DialPad
If enabled, When the phone is Offhook it will automatically dial out the
number punched in after the number of seconds that the user had set.
Live DialPad Expire
Time
Set the Live DialPad expire time before initiating the call using Live DialPad
feature. Interval is between 2s and 15s. Default value is 5s.
Enable Automatic
Redial
If enabled, the phone will redial the number a configured number of times
with a configured interval (in seconds) in between each redial.
Automatic Redial
Times
The number of times to attempt to call using Automatic Redial feature.
Automatic Redial
Interval
The interval between each call attempt using Automatic Redial feature.
Bypass Dial Plan
Through Call History
and Directories
Enable/Disable the dial plan check while dialing through the call history and
any phonebook directories. The default setting is “No”.
Disable Call Waiting
Disables the call waiting feature. The default setting is “No”.
Disable Call Waiting
Tone
Disables the call waiting tone when call waiting is on. Default setting is “No”.
Ring For Call Waiting
Disables / enables the call waiting tone when the call waiting feature is
enable. Default is disabled.
Disable Busy Tone on
Remote Disconnect
Disables the busy tone heard in the handset when call is disconnected
remotely. The default setting is “No”.
Disable Direct IP Call
Disables Direct IP Call. The default setting is “No”.
Use Quick IP Call
mode
When set to “Yes”, users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address.
To dial quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No SIP