User's Manual

FIRMWARE VERSION 1.0.4.23 GXP1100/GXP1105 USER MANUAL Page 23 of 46
• G-723
• G-729
10
"MAC Address" Announces the MAC address of the unit.
13
"Firmware Server IP Address" Announces current Firmware Server IP address. Enter
12 digit new IP address.
14
"
Configuration Server IP
Address"
Announces current Config Server Path IP address.
Enter 12 digit new IP address.
15
"Upgrade Protocol" Upgrade Protocol for firmware and configuration update.
Enter 9 to toggle between HTTP, TFTP and HTTPS.
16
"Firmware Version" Firmware version information.
17
"Firmware Upgrade" Firmware upgrade mode. Enter 9 to toggle among the
following three options:
• always check
• check when pre/suffix changes
• never upgrade
47
"Direct IP Calling" Enter the target IP address to make a direct IP call, after
dial tone. (See Make a Direct IP Call section)
86
"Voice Mail" Announces number of voice mails.
99
"RESET"
Enter MAC address to restore factory default setting.
(See Restore Factory Default Setting section)
Press 9 to reboot the device.
Others
"Invalid Entry" Automatically returns to Main Menu.
CONFIGURATION VIA WEB BROWSER
The GXP1100/GXP1105 embedded Web server responds to HTTP/HTTPS GET/POST requests.
Embedded HTML pages allow a user to configure the IP phone through a Web browser such as Microsoft’s
IE, Mozilla Firefox and Google Chrome.
To access the GXP1100/GXP1105 Web GUI:
1. Connect the computer to the same network as the phone;
2. Make sure the phone is turned on and wait until the indicator on the top right corner turns from RED to
OFF;
3. Take the handset off hook. Enter *** and then press 02 to hear the IP address;