User's Manual
Grandstream Networks, Inc. DP715-US/DP710-US User Manual Page 22 of 43
Firmware 0.0.0.8 Last Updated: 03/2012
Stop watch
1. Press .
2. Scroll with to Tools and press .
3. Scroll with or to Stop Watch and press .
4. Press Start, to start the watch.
5. Press Stop, to stop the watch.
6. Press Start again to allow the stop watch to continue to run.
7. Press Reset to reset the stop watch to 00:00.
UNDERSTANDING DP715 VOICE PROMPT
DP715 has a built-in voice prompt menu for simple device configuration. The IVR menu and the LED button
work with any of the Handset. Pick up the handset and dial “***” to use the IVR menu.
Table 6: DP715_US IVR Menu Definitions
Menu Voice Prompt Options
Main Menu
“Enter a Menu Option”
Press “*” for the next menu option
Press “#” to return to the main menu
Enter 01-05, 07,10, 13-17,47 or 99 menu options
01
“DHCP Mode”,
“Static IP Mode”
Press “9” to toggle the selection
If using “Static IP Mode”, configure the IP address information using
menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information comes from
the DHCP server automatically after reboot.
02
“IP Address “ + IP address The current WAN IP address is announced
If using “Static IP Mode”, enter 12 digit new IP address. You need to
reset the DP715 for the new IP address to take Effect.
03
“Subnet “ + IP address Same as menu 02
04
“Gateway “ + IP address Same as menu 02
05
“DNS Server “ + IP address Same as menu 02
07
Preferred Vocoder
Press “9” to move to the next selection in the list:
• PCM U / PCM A
• iLBC
• G-726
• G-723
• G-729
10
“MAC Address” Announces the Mac address of the unit.
13
Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12 digit new
IP address.
14
Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12 digit
new IP address.
15
Upgrade Protocol Upgrade protocol for firmware and configuration update. Press “9” to
toggle between TFTP / HTTP / HTTPS
16
Firmware Version Firmware version information.
17
Firmware Upgrade Firmware upgrade mode. Press “9” to toggle among the following
three options: