- Grandstream Dp710 Dect Ip Accessory Handset And Charger Manual
Firmware version 1.0.0.23  DP715/DP710 User Manual   Page 32 of 52 
b.  A  quick  busy  tone  followed  by  a  restored  call  (on  supported  platforms  only): This  means  the 
transferee has received a 4xx response for the INVITE and we will try to recover the call.  The busy 
tone is just to indicate to the transferor that the transfer has failed.  
c.  Continuous busy tone: The phone has timed out. 
Note:continuous  busy  tone  does  not  indicate  the  transfer  has  been  successful,  nor  does  it  indicate  the 
transfer has failed.  It often means there was a failure to receive second NOTIFY – check firmware for most 
recent release. 
Attended Transfer 
This  function  is  applicable  using  the  Handset  for  VoIP  calls  only.  Assume  that  parties  A  and  B  are  in 
conversation. PartyA wants to Attend TransferB to C: 
1.  A presses RECALL on the Handset for dial tone. 
2.  A then dials Caller C’s number followed by # (or wait for 4 seconds). 
3.  If C answers the call, A and C are in conversation. Then A can hang up to complete transfer. 
4.  If C does not answer the call, A can press “flash” to resume call with Caller B.  
Note:When Attended Transfer fails and A hangs up, the DP715 will ring back user A to remind A that B is 
still on the call. A can pick up the phone to resume conversation with B. 
3-WAY CONFERENCING 
The DP715 supports Bellcore style 3-way Conference. 
Instructions for 3-way conference: 
Assume that partiesA and B are in conversation. PartyA wants to bring C into a 3-way conference: 
1. A presses RECALL (on the Handset) to get a dial tone. 
2. A dials C’s number then # (or wait for 4 seconds).  
3. If C answers the call, then A presses RECALL to bring B, C in the conference. 
4. If Cdoes not answer the call, A can press RECALL back to talk to B. 
5. If A presses RECALL during conference, C will be dropped out. 
6. If A hangs up, the conference will be terminated for all three parties when configuration “Transfer  
on Conference Hang up” is set to “No”. If the configuration is set to “Yes”, A will transfer B to C so 
that B and C can continue the conversation. 










