Full Product Manual

GrandPrix Two-Post Lifts 42 P/N 5900209 — Rev. D3 — Feb. 2020
Connecting the Lifting Cables
The threaded ends of the Lifting Cables, which were installed in the Top Trough earlier in the
installation, connect to the Lift Heads inside the Offside and Powerside Posts; two Lifting Cables per
Post.
To connect the Lifting Cables:
1. Inside the Powerside Post, insert the threaded ends of the two Lifting Cables through the holes
adjacent to the Retainer on the top of the Lift Heads.
The holes on the Powerside Post (shown below) are widely spaced, compared to the holes on the
Offside Post.
2. Place one M18 washer and M18 Nyloc nut on the threaded end; tighten the nuts until taut, making
sure both cables have equal tension.