Assembly Instructions

ManualsBrandsGrand Aspirations ManualsElectric Fireplaces34" Belmont Curved Linear Fireplace in Black

CONTROL PANEL FUNCTIONS

When the heat function is used for the first time, a slight odor may be present.

This is normal and should not occur again unless the heater is not used for an

extended period of time.

NOTICE

CONTROLS FUNCTION

Flame Button Press Flame Button to desired flame color.

10 different color options.

Flame +/- Press Flame (+/-) Button to desired flame brightness.

3 options. ONLY works when flame button is ON.

Fuel Bed Press Fuel Bed Button to desired fuel bed color.

(10 different color options).

Fuel Bed +/- Press Fuel Bed (+/-) Button to desired brightness.

3 options. Only works when flame button is ON.

Back Light Press Back Light Button to desired back light color.

10 different color options.

Back Light

+/-

Press Back Light (+/-) Button to desired back light

brightness. 3 options. ONLY works when Back Light button

is ON.

Flame Speed Press Flame Speed Button to desired flame speed.

5 options.

Timer +/-

Press Timer (+/-) once to increase timer setting by ½ hour

increments. Maximum timer setting is 7½ hours. Indicator light

will illuminate. Press Timer (+/-) button again to turn off timer.

Heater

Press Heater Button once, 750W (LOW HEAT) heater turns

on and the fan starts to blow warm air. Press Heater Button

again, turns on 1,500W (HIGH HEAT) heater turns on and blows

hot air. Press Heater Button again and the heater turns OFF.

The fan will continue to blow to allow heater to cool down, and

then turns off. NOTE: The Heat Enabling Switch (on the back

of the unit) must be ON for the Heater function to operate.

Thermostat

Control Knob

Heater must be ON either LOW or HIGH heat for the

thermostat function to operate. The heat output is controlled

by the Thermostat Control Knob. Set the Thermostat Control

Knob to the maximum position initially. When the room reaches

the desired temperature, reduce the setting by slowly turning

the thermostat knob, counterclockwise until the heater will click

and turn off. The heater will then maintain the room temperature

at the desired level. NOTE: The Heat Enabling Switch (on the

back of the unit) must be ON for the Heater function

to operate.

Main Power

ON/OFF

Press ON. Power turns ON. All functions are enabled. Press

OFF. Power, flame effect, and all functions turn off.

THERMOSTAT

OFF