Manual

9. Assembly
PNEG-1510 Top Dry 24', 30' and 36' Manual Batch 75
Transition Installation (TR-4734)
Before cutting the opening check that TR-4734 is the transition that was ordered.
When installing the GSI aeration transition, it will be necessary to field cut a hole into the bottom sidewall
ring (usually straight across from the unload auger). Refer to Figure 9AA for proper dimensions of
cut-out. The base angle will also need to be cut at entrance collar cut-out. Take note of the Figure 9AA
showing the 1" dimension from bottom of entrance collar side bracket to concrete. This is important for
proper fit of transition.
NOTE: Entrance collar side bracket must be bolted on the inside of the bin sidewall.
Figure 9AA As Viewed from Inside Bin
Part # Description Qty
S-275 5/16"-18 x 3/4" Bin Bolt Grade 5 125
S-280 #10- 16 x 5/8" Self-Drilling Screw 10
S-3651 Tube Caulk - Gray Butyl #506-15 1
S-396 5/16"-18 Hex Nut Grade 2 125
S-7264 Spec Neoprene Seal Strip w/ ADH 10'