Manual

9. Assembly
62 PNEG-1510 Top Dry 24', 30' and 36' Manual Batch
Top Dry Access Door Assembly (TD-100996)
1. Assemble the Z-frames (TD-100991 and TD-100992) and then attach the frames (TD-100991 and
TD-100992), to the inside of the access door plate (TD-100990). NOTE: The first set of Z-frames
comes pre-assembled to the access door plate.
2. Now attach the top and bottom rear door catches (TD-101020) to the back of the Z-frames. Referring
to the layout, position the catches with the left hand most hole aligned with the center hole of the
access door plate.
3. Using washers to center the doors over the opening, attach the top access door (TD-100993) and
the inside access door (TD-100994) to the Z-frames. Utilize the lock washers to secure the bolts to
the doors. Do not overly tighten the lock washers. This allows the doors to move freely.
4. Now attach the handles (D02-0045 and D03-0512) to the doors. NOTE: The locking handles
along with the hardware labeled “out”, go to the outside doors. The rear handles have their own
hardware package.
5. With the nut and bolt supplied, attach the appropriate latches to the handles and lock them.
(See Figure 9L.) Adjust front latches (TD-101021) to catch the inside lip of the front Z-frames. Adjust
rear latches (TD-101022) to fit the slot in the top and bottom catches attached to the rear Z-frames.
6. Attach the assembled access door to the access door panel (TD-101025).
Figure 9L
Ref # Part # Description Qty
1 TD-100990 Access Door Plate 1
2 TD-100991 Access Top/Bottom Z-Frames 4
3 TD-100992 Access Door Side Z-Frames 4
4 TD-100993 Top Access Door 2
5 TD-100994 Inside Access Door 2
x TD-101020 Rear Door Catches 2
x TD-101021 Outside Door Latches 2
x TD-101022 Inside Door Latches 2
x D03-0512 Lockable Handle 2
x D02-0045 Gasket for Lockable Handle 2
x ACD-4513 Access Door Handle w/ Gasket 2