Manual

9. Assembly
PNEG-1510 Top Dry 24', 30' and 36' Manual Batch 57
Pulley Assembly
Finish assembling the center collar by adding the cross channel. Position the pulley assembly to the cross
channel in the middle of the center collar assembly. Use a 3/8" x 1" hex head cap bolt to fasten assembly
to the cross channel. Position the pulley in the direction of the desired winch location on the sidewall.
(See Figure 9D.)
Figure 9D
Field drill five (5) 3/8" diameter holes as shown at left. Attach the pulley assembly with 5/16" x 3/4" bolts
with the neoprene on the inside of the bin. (See Figure 9E.)
Figure 9E