Accessories PNEG-1802 User guide

4. Inside Ladder Installation
PNEG-1802 Inside Ladder Instructions 33
Inside Ladder Installation (for Stir-Ator Option)
Inside Ladder Placement
The inside ladder package for Stir-Ator option includes the ladders and double the amount of short
standoff brackets. Begin by positioning the ladder directly under the manhole roof panel as shown in
Figure 4AB and install the top standoff bracket as shown in Figure 4AC on Page 34. Then, place the
standoff brackets every 22" vertically on the sidewall sheets using the horizontal seam holes for every
other hole location. Use 5/16" x 3/4" bin bolts to attach the standoff brackets to the sidewall of the grain bin.
NOTE: Refer to general detail information section on PNEG-1420 for additional details for standoff bracket
to ladder assembly.
Figure 4AB