Accessories PNEG-1802 User guide

4. Inside Ladder Installation
22 PNEG-1802 Inside Ladder Instructions
Inside Standoff Bracket and Ladder Placement
Refer to Figure 4N and Figure 4O and follow the correct dimensions as shown. The top standoff bracket
should be in line with the top horizontal seam. Check the 4' ladder section to make sure the ladder rung
dimples are to the top surface and attach to the standoff bracket. (See general detail information
section on PNEG-1420.) Now all standoff brackets must be installed every 16" and attached to each
4' section required.
Figure 4N Inside Stiffened
Figure 4O Outside Stiffened