Accessories PNEG-1802 User guide

4. Inside Ladder Installation
16 PNEG-1802 Inside Ladder Instructions
Inside Standoff Bracket and Ladder Placement
Refer to Figure 4E and follow the correct dimensions as shown. The top standoff bracket should be in line
with the top horizontal seam. Check the 4' ladder section to make sure the ladder rung dimples are to the
top surface and attach to the standoff bracket. (See general detail information section on PNEG-1420.)
Now all standoff brackets must be installed every 16" and attached to each 4' section required.
(See Figure 4F on Page 17.)
Figure 4E