Accessories PNEG-1785 Owner's manual

4. Assembly Instructions
PNEG-1785 NCHT “X” Series Ladders 59
5. Attach the ladder flare to the ladder using 5/16" x 3/4" bin bolt (S-275) (E) and flange nut (S-3611)
(F). You must drill the bottom hole through the ladder and use 5/16" hardware. (See Figure 4AW.)
Attach the narrow safety cage bracket, cage hoops and cage splice brackets to the ladder flares and
platform posts. This must all be assembled at the same time using 5/16" hardware.
NOTE: Make sure the ladder flares are vertical and parallel to the platform posts by adjusting
the splice brackets. The ladder should be square to the platform.
Attach safety cage hoop splice to handrail post using 5/16" x 3/4" bin bolt (S-275) (E) and flange nut
(S-3611) (F).
Attach safety cage hoop splice to safety cage hoop using 5/16" x 3/4" bin bolt (S-275) (E) and flange
nut (S-3611) (F).
Attach safety cage narrow bracket to formed ladder flare using 5/16" x 1-1/4" bolt (S-277) (G) and
flange nut (S-3611) (F).
Figure 4AW
Ref # Part # Description Ref # Part # Description
A LDR-5167 Safety Cage Hoop Splice G S-277 5/16" x 1-1/4" Flange Bolt
B LDR-5164 Safety Cage Hoop Standard
H 4FOOTRF 4' Roll Formed Ladder
C LDR-5163 Safety Cage Narrow Bracket I LDR-5178 Intermediate Platform Ladder bracket - Left
D LDR-5161 Formed Ladder Flare
J LDR-5177 Intermediate Platform Ladder bracket - Right
E S-275 5/16" x 3/4" Bin Bolt K LDR-5174 Platform Wall Bracket - Left
F S-3611 5/16" Flange Nut