Accessories PNEG-1785 Owner's manual

4. Assembly Instructions
48 PNEG-1785 NCHT “X” Series Ladders
10. Place clamp assembly down the column every 32" center to center. Be sure to mount C-channel
before putting nut onto the middle bolt of the clamp assembly. Do not put clamps less than 32"
apart at the base of the column. 36" Column shown as example. (See Figure 4AL.)
Place first clamp assembly (center of middle hole) at 30-15/16" below horizontal seam for starting
point. Adjust to attach platform brace as needed.
Place clamp assembly down column with 32" spacing from center of middle hole to center of
middle hole.
* Reference dimension.
Figure 4AL
Ref # Part # Description
A LDR-5342 C-Channel
B Clamp Assembly