Accessories PNEG-1773 Instruction Manual

4. Assembly Instructions
60 PNEG-1773 42'-135' “X” Series Ladder, Cage and Platform
Platform and Cage Package
5. Attach the ladder flare to the ladder using 5/16" hardware. You must drill the bottom hole through the
ladder and use 5/16" hardware. (See Figure 4AP below and Figure 4AQ on Page 61.)
Attach the narrow safety cage bracket, cage hoops and cage splice brackets to the ladder flares and
platform posts. This must all be assembled at the same time using 5/16" hardware.
NOTE: Be sure the ladder flares are vertical and parallel to the platform posts by adjusting the
splice brackets. The ladder should be square to the platform.
Figure 4AP