Accessories PNEG-1773 Instruction Manual

4. Assembly Instructions
48 PNEG-1773 42'-135' “X” Series Ladder, Cage and Platform
NOTE: See table on Page 44 for correct ladder and safety cage layout.
1. Assemble the wall bracket to the wall angle using 3/8" hardware. (See Figure 4AC on Page 49.)
NOTE: The wall angle must be assembled on top of the previous wall angle to provide a flat surface
to mount the wall bracket.
2. Assemble the wall braces to the wall bracket and the horizontal sidewall seam using 5/16" hardware.
IMPORTANT: Use a hole in the horizontal seam and two (2) holes in the wall braces that allows the
wall bracket to be aligned with the above wall bracket. If they are NOT aligned, the
ladder will not be straight.
3. Attach the next ladder section to the upper section using the splice plates and 5/16" hardware.
(See Figure 4AB.)
Assemble the ladder standoff brackets to the ladder and wall bracket using the ladder standoff
wedges and 5/16" hardware. (See Figure 4AC on Page 49.)
Figure 4AB