Accessories PNEG-1773 Instruction Manual

4. Assembly Instructions
34 PNEG-1773 42'-135' “X” Series Ladder, Cage and Platform
42'-60' Ladder Eave Platform Assembly
Ladder Eave Platform Package
1. Figure 4Q below and Figure 4R on Page 35 shows the assembly of the platform supports. Use
5/16" hardware at all the connection points. (Platform floor will have to be attached at the same time
as support angles.)
NOTE: When installing the top wind ring, do NOT use the top set of holes in the stiffener.
NOTE: Leave all hardware loose until completely assembled.
2. Left platform bracket must be line up with stiffener roof rib and rafter of beam if present
in roof.
Figure 4Q