Accessories PNEG-1773 Instruction Manual

4. Assembly Instructions
24 PNEG-1773 42'-135' “X” Series Ladder, Cage and Platform
Platform Ladder Bracket Package - Right Hand Side Assembly
9. Attach the wall angle to the sidewall sheet using the hole 9-3/8" from the stiffener hole pattern with
3/8" hardware. Assemble the wall bracket to the wall angle with 3/8" hardware and tighten.
(See Figure 4J below and Figure 4K on Page 25.)
Attach left and right intermediate platform ladder bracket to the wall bracket and platform support with
5/16" hardware.
NOTE: Do not force the wall bracket in or out.
Assemble the ladder and ladder brackets to the wall bracket using 5/16" hardware. The top ladder
rung must be level with the platform floor.
Figure 4J