Accessories PNEG-1753 Owner's manual

PNEG-1753 Fall Restraint Reinforcement Kit 7
3. Installation in Newly Constructed Tanks
This section is for the installation of the Fall Restraint Reinforcement Kit to be installed in newly
constructed tanks only. Refer to Chapter 4 on Page 13 for installing in existing tanks.
105'-25K Roof Fall Restraint Reinforcement Installation Instructions
for CRP-6945
The center collar and one eave tension plate will need to be drilled to allow for the assembly of this
reinforcement kit.
1. Install CRP-6943 to every roof beam stiffener as shown in Figure 3A using four (4) 3/8" x 1-1/2"
grade 8 flange bolts (S-7928) and flange nuts (S-9373).
Figure 3A