Accessories PNEG-1451 Owner manual

7. 4.00" Corrugation Farm Commercial Hopper Tanks (FCHT) 4-6 Rings
78 PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
Access Door Safety Cage Hoop Assembly
Before attaching any pieces to the ladder or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section. (See general detail information on Page 12 for proper installation
instructions.) Bolt the safety cage hoop adjuster plates onto the extension angle as shown in Figure 7T.
For the middle hoop assembly, bolt the safety cage hoop adapters and safety cage hoop half together
using the proper holes, based upon the bin diameter. (See Page 74.) Be sure to use the 5/16" x 3/4" bolt
with the head of the bolt to the inside of the safety cage. Bolt this assembly to the safety cage bracket
and hoop adjuster plate, tighten as you go. The bottom assembly requires two (2) hoop halves and will
be positioned just below the platform as shown in Figure 7T. Use the safety cage hoop adjuster angle to
secure the two (2) hoop half assemblies to the vertical entrance angle on the platform assembly. To finish
the installation, secure the access door platform assembly to the existing safety cage assembly using the
safety cage hoop adapters as shown in Figure 7T.
NOTE: See Page 75 and 79 for vertical support, safety cage and bell cage installation details to complete
the ladder assembly.
Figure 7T
Safety cage assemblies shown for
reference only. See Page 76 for
installation details.
67-1/2" Extension angle (LS-6775)
(See general detail information
on Page 12 for proper installation.)
Left hand platform
assembly (See Page 76
for assembly details.)
Cage hoop bracket (See general
detail information on Page 12 for
proper installation.)