Accessories PNEG-1451 Owner manual

6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 55
Intermediate and Base Safety Cage Hoop Assembly
Before attaching any pieces to the ladders or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section. (See general detail information on Page 12.) Bolt the safety cage hoop
adjuster plates onto the extension angle as shown in Figure 6V. Bolt the safety cage hoop adapters
and safety cage hoop halves together using the proper holes based on the diameter of the grain bin.
(See Page 49.) Be sure to use the 5/16" x 3/4" bolt with the head of the bolt to the inside of the safety cage.
Bolt these assemblies to the safety cage brackets and hoop adjuster plates, tighten bolts as you go. The
bottom assembly requires two (2) hoop halves and will be positioned just below the platform as shown in
Figure 6V. Use the safety cage hoop adjuster angle to secure the two (2) hoop half assemblies to the
vertical entrance angle on the platform assembly.
NOTE: See Pages 50 and 51 for vertical supports, safety cage and bell cage installation details to
complete the intermediate ladder assembly.
Figure 6V
Right hand platform assembly
(See Page 47 for assembly details.)
LS-6775 Extension angles
(See general detail information
on Page 12 for proper installation.)
Vertical entrance angle (See
platform assembly on Page 47.)
Cage hoop bracket (See general
detail information on Page 12 for
proper installation.)