Accessories PNEG-1451 Owner manual

5. 2.66" Corrugated Commercial Hopper Tank 4-9 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 35
24"-48" Safety Cage Bell Sections
Attach the vertical supports to the hoop half assembly from the final safety cage installation using
5/16" x 3/4" bolts and nuts (with the heads on the inside of the cage). Assemble the special bell safety
cage hoop halves and attach to other end of vertical supports. The vertical support must be bent at the flat
area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as shown in
the Figure 5K on Page 29. Once the safety cage brackets are installed, attach the bell safety cage hoop
half assembly to the safety cage brackets and tighten bolts.
NOTE: The safety cage bell section is to be used at the point of termination of the safety cage and should
be just above the concrete (generally 7' to 8').
Figure 5U 24" Bell
Figure 5V 48" Bell