User Guide

1031FP-INS-LAB-RevA11 10
6. Screw the push handles into the mast and tighten the
nuts.
7. Insert spreader bar attachment rod into spreader bar.
Insert spreader bar rod into the U-bracket at the end of
the boom. Align holes. Insert spreader bar attachment
bolt and tighten.
8. For shipping purposes, the boom is in its lowest posi-
tion. To elevate, turn the pump knob clockwise until
hand tight and operate the pump handle.
9. Operate the foot pedal to
adjust the base width.
The picture at near right
shows the base end op-
posite the foot pedal at
minimum width; the left
food pedal has been com-
pletely depressed.
The picture at far right
shows the base end op-
posite the foot pedal at
maximum width; the right
foot pedal has been com-
pletely depressed.
install push handles
install spreader bar
elevate boom
base at minimum width base at maximum width