Service Manual, Parts List, Diagrams and Assembling Charts

-~,
(
Special PI.ecautions for:
2¥ x 3± R. a. Series a GRAFIEX
Biv_p lvi n g _ _P_e=j2¥
Attaching Back to Camera
Sliding Lock or Retainer Stl`ip
Velvet
Wood Spacer Strip
Revolving Back Ring
Revolving Back Ijatch
li___ ___Attach±_pg___Back to Camera.
Ihe revolving back (#24.25) is attached to the
Camera body with eight #1 x ±`' flat head wood
scl`ews from the back and three #1 x i" oval
head wood sol.ews from the side.
LS|i di ng _I Qcl€ . _ i.{._#? 7J.. _ Q_I_ _ Re ta±±±±ngj±±±_i.p i_#2Z±J .
i The sliding lock (#27) is secured to wood
S8:::: {#;EB£¥£3:9) by two round head wood
h The retaining strip (#273) is secured by
four rfl x z'. oval head wood screws (#15281-4-)
to wood spacel` stl'ip (#2269).
L]I±±.Iret I._ =Fej[Q_lvinj3 F=g±p_e _ (.#?=Z5£2.
Section 20D
Page 1
fr Heir.ove the wood spacer strips (#2269). See pal`agraph beloiF.
h Remove old velvet and cement. Use 3H-EC-880 for. the new velvet.
CAUTION: Do not saturate the velvet i^rith the adhesive .... it willdestl'ey the plush
texture. II.in loose threads around the opening.
4+ _ ngoo_d___=SpLa_Qe_r St_I_ip (#2?6_2)=.
%re::e.t#£;gB£:a;e:n3tf:8mL:h:e%::=dbfrto#o t#= £u5;±g: :£g: £¥aEwfo€± =c±,:w:vE±L38%£.¥;::..
I'evolve the frame as illustpated for access to the back scl.ews.
h If the wo.od spacer is r eplaced, it will be necessary to perfol.ate new holes for the
scl`ews. Reassemble the back screws fit.st.
i____a_ev.ol_¥±ngEapk..Ring_I_rf2_E§J.
i The I'evolvi.ng back ring (#258) is secured by eight special flat machine scl'ews. Re-
move wood spacer strips and velvet from revolving fl'ame for access to screw heads.
• h Lubricate the bearing surface vel.y lightly with #107 I.ubriplate -or Parawax.
•.,
fu .Reassemble rin.g screws .... tighten to equal tension. Check I`evolving operation. See
paragraphs 3 and 4 above for velvet and spacer strip replacement.
£tuLevc>1viQLg__Ea__c_*___Latiqut.
¥e :::.e::¥°±¥±:Eeb:::n±:::hf::::in::¥e.::i;L{#:gz}?ed On Page 2 of this section. All pal.ts
h The latch lev:r .(#256) should be flat and have the inside stirface lubricated.very
lightly with rfl07.Lubl.iplate or Parawax. If.necessary, file latch s.top _to fit _I.ing notch.
fr Noti.ce required ri.vets mentioned in pal.ts listing when ol`dering I.eplacements.