Product Manual

4077-INS-LAB-RevB09 25
Fixing a Paper Jam
When the recorder malfunctions or sounds unexpectedly, open the recorder door to see
if there is a paper jam. Remove the paper jam as follows:
1. Cut the record paper from the paper notch edge.
2. Open the recorder door and revolve the left recorder gear.
3. Pull out the paper.
4. Reload the paper.
TURNING ON THE FETAL MONITOR
WARNING: If any sign of damage is detected, or the monitor displays any error
messages, DO NOT use the Fetal Monitor on a patient. Immediately contact your
hospital biomedical engineer or Graham-Field Customer Service at 800-347-5678.
Press the power switch. You will hear a short sound and the power indicator will illu-
minate. If PrintTest at the menu is set to ON, the system will print a test baseline. After
approximately ten seconds, after self-test, the system will display the monitoring screen;
you can then perform normal monitoring.
CONNECTING TRANSDUCERS AND CABLES
WARNING: Only connect transducers and cables supplied by Graham-Field to the
Fetal Monitor.
WARNING: Before each use, check transducers and cables for visible damage. If
damage is found, replace them at once.
Caution: To avoid damage, be gentle when connecting and using transducers.
1. When connecting transducers to the Fetal Monitor, position the transducer's arrow
symbol up.
2. Connect all the necessary transducers, and cables between the monitor and the pa-
tient.
TURNING OFF THE FETAL MONITOR
After nishing the monitoring operation, press the power switch for approximately three
seconds to turn off the Fetal Monitor.
power switch