SDS

Office 1.801.886.9495 Fax 1.801.886.9497

The SDS should be read before product disposal. Pass SDS information to all persons who could be exposed to the

product. The SDS has been prepared according to OSHA hazard Communication Standard (29 CFR 1901.1200). To the best

of our knowledge, the information contained herein is accurate and based on sources believed to be reliable. However,

since data, safety standards and government regulations are subject to change, NewLook International, Inc. makes no

warranty, either expressed or implied, with respect to the completeness or continuing accuracy of the information

contained herein and disclaims all liability for reliance thereon. The data on this sheet is related only to this specific

material. It may not be valid for this material, if used in combination with other materials. It is the end users responsibility

to determine suitability and completeness of this information with regards to a particular use. Additional information may

be necessary or helpful for specific conditions and circumstances of use. Unknown hazards may exist and this material

should be used with caution. NewLook International, Inc. assumes no legal responsibility for use or reliance upon this

data.

HMIS: H=2, F=1, R=0, P=0 (0 = Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe)

ACGIH: American Conference of Government Industrial Hygienists

CAS: Chemical Abstracts Service Registry

MISHA: Mine Safety and Health Administration

NFPA: National Fire Protection Association

NIOSH: National Institute for Occupational Safety and Health

OSHA: Occupational Safety and Health Administration

PEL: Permissible Exposure Limit (OSHA)

STEL: Short Term Exposure Limit (ACGIH)

TLV: Threshold Limit Value (ACGIH)

IARC: International Agency for Research on Cancer

HMIS: Hazardous material Identification System

Revision Date: 22 – May – 2015