SDS
© 2015 NewLook International, Inc. www.getnewlook.com 1525 S. Gladiola Street Suite 8, Salt Lake City, UT 84104
Office 1.801.886.9495 Fax 1.801.886.9497
2
Section 3
Composition/ Information on Ingredients:
Chemical Name
CAS Number
Weight %
Dieethylene Glycol Monoethyl Ether
111-90-0
10 – 20%
Zinc Ammonium Carbonate Compound
38714-47-5
25 – 30%
Titanium Nano Drivers
13463-67-7
5 – 10%
Tributoxy Ethyl Phosphate
78-51-3
5 – 10%
Polymeric Hybrid Nano Particles
25586-24-7
1.0 – 3%
Polycarbonate Nano Drivers
25037-45-0
15 – 25%
Hydrogen Hydroxide
7732-18-5
50 – 60%
Section 4
First Aid Measures:
Precautionary Statements: Response
Inhalation: Move to fresh air. Give artificial respiration, if not breathing. If breathing is difficult, seek medical attention.
Ingestion: If swallowed, DO NOT induce vomiting. Immediately give 2 glasses of water. Seek medical attention immediately.
Eye Exposure: Do not rub eyes. Immediately flush eyes with large amount of water for at least 15 minutes, occasionally lifting
upper and lower eyelids. Seek medical attention immediately.
Skin Contact: Immediately wipe away excess product. Wash exposed area with water, then soap and water. Remove and clean
contaminated clothing. If irritation persists, seek medical attention.
Section 5
Firefighting Measures:
Suitable Extinguishing Media: Product is non-hazardous. Use dry chemical foam, CO
2
, Water Fog.
Unsuitable Extinguishing Media: Not Known
Specific Hazards in Case of a Fire: Upon burning, toxic gases may be released.
Special Protective Equipment and Procedures for Firefighters: Wear self-contained breathing apparatus with a full-face piece
operated in positive pressure mode and full protective clothing.
Section 6
Accidental Release Measure:
Personal Precautions: Wear personal protective equipment, such as a respiratory mask.
Environmental Precautions: Keep people away. Ventilate confined spaces. Open all windows and doors. Flush with water to a
tank or an open well ventilated area. Recover by pumping. Keep product out of sewers, waterways and soil by dyking or
impounding. Absorb with sand, earth, or other suitable absorbent, like NewLook’s Absorbent. Control run-off and isolate discharge
material for proper waste disposal. Use tightly sealed containers and label properly. Dispose of in accordance with local, state and
federal regulation.
Section 7
Handling and Storage:
Precautions for Safe Handling: Store in a cool, dry place with adequate ventilation. Keep containers closed when not in use. Do
not store in metal containers. Product will freeze if stored below 59°F. Product damage will occur if frozen.