Instruction manual

3
EN
Unpacking
To unpack the unit, proceed as below:
Take the unit out of the carton.
Remove all pieces of the packing.
Remove any possibly extant labels on the unit
(do not remove the rating plate).
Requirements for the installation loca-
tion
For safe and awless operation of the unit, the
place of location must meet these prerequisites:
The unit must be set up on a rm, at, level
and non-slip base that has sufcient load
bearing capacity.
Make sure the unit cannot fall over.
Select the location so that children cannot
reach the hot surfaces of the unit and cannot
touch the cable.
Before the rst use
Read these operating instructions thoroughly
and keep them handy for referral later on.
This unit brings water to boil in a few minutes.
To clean the unit, rst ll the unit with clear,
cold water and then boil it. Subsequently pour
away the water.
Boiling water
Take hold of the base station and unwind the
cable as far as it goes.
Open the lid and ll the unit with water
Important
Make sure you do not exceed the internal maxi-
mum lling level mark.
Fill the unit so that the water level is denitely
between the minimum and maximum indicator
line.
Close the lid and put the unit back onto
the base station .
Plug the plug into the electric socket.
Please press the button for the desired tem-
perature
Temperature
Options
Ideal for:
70°C Japanese “Gyokuru
Asahi” Tea
80°C All Green Teas and
instant beverages
90°C Oolong teas, half-
fermented
All black teas,
herbal- or fruit tea
blends
The kettle is now turned on.
Important
The current temperature is rstly indicated by
the respective glowing button and the button
of the desired/chosen temperature is blinking.
3 short beeps and the blue-glowing button
of the chosen temperature indicate that the
heating-process is completed.
Important
The temperatures can be adjusted at any time
of the heating-process, provided that the desi-
red temperature has not been reached, yet.
Once you take off the kettle from the contact
base, the kettle is turned off.
For a new/repeated heating-process please
press the button for the desired temperature.
Important
If you have chosen a higher temperature setting
during the rst heating-process and now desi-
re a lower temperature of the remaining water,
please press the button for the respective (lo-
wer) temperature.
Tips
Please always heat/boil fresh cold water.
Black teas, herbal- and fruit tea blends should
always be brewed with boiling water.
For Green Tea, the water temperature should
approximately be 80°C in order to avoid that
too many of the bitterns get released in the
infusion.
In case of bad water quality, we recommend
you to use still mineral water.
The right brewing time decisively inuences
the effect and the taste of tea.
After 2 to 3 minutes, tea acts as a stimulant
on the central nervous system and has a
rather mild aromatic, not too acerbic, taste.
After 4 to 5 minutes, tea has a calming effect