EN Instruction Manual Universal Slicer UNA
EN Unpacking position ■■Place the cutting goods on the carriage. To unpack the unit, proceed as below: ■■Adjust the desired cutting width by turning ■■Take the unit out of the carton. the hand wheel. ■■Remove all pieces of the packing. ■ ■ Push the needed switch „Pulse“ or „Perma■■Remove any possibly extant labels on the unit nent“ (do not remove the rating plate).
EN plug before using it. Do not put a damaged ■■Lubricate the gliding ring and gear on the inunit into operation. side of the blade with Vaseline after cleaning. ■■Replace the blade and the blade cover plate ■■If the machine’s connecting cable is damaged, continued use of the machine is only in reverse sequence. allowed it has been replaced with a new one.
EN ■■Check to make sure the limit stop is closed (cutter blade is covered). ■■Do not use any aggressive or abrasive cleaning agents and do not use any solvents. ■■Do not scratch off stubborn soiling with hard objects. ■■Do not wash in the unit in water or immerse it into water.
