EN Instruction Manual Coffee grinder CM 90 Serie
Table of content Safety Instructions.................................. 3 Before first use...................................... 4 Unpacking............................................ 4 Requirements for the installation location..... 5 Operating and speed settings..................... 5 Grind setting ........................................ 5 Grinding coffee...................................... 5 Grinding coffee directly in the group handle...
Safety Instructions This appliance complies with the statutory safety regulations. Improper use can, however, lead to personal injury and property damage. to repair the appliance during the warranty EN period, otherwise the warranty expires for subsequent damages. ●● To handle the appliance safely, follow the instructions below: ●● ●● ●● ●● Check the appliance for external, visible damage to the housing, the connector cable and the plug before using it. Do not put a damaged appliance into operation.
clients in hotels, motels and other residental type environments; bed and breakfast type environments. ●● ●● ●● ●● ●● ●● ●● 4 If the supply cord is damaged, it must be replaced by the manufacturer, its service or similarly qualified persons in order to avoid a hazard. Always pull the supply line from the electric socket using the connector plug, not on the connector cable. Never operate the appliance with wet hands. Do not use the packaging material as a toy. Danger of suffocation.
Requirements for the installation location Grind setting For safe and flawless operation of the appliance, the place of location must meet these prerequisites: You can influence the composition of the coffee with various grind settings. ●● ●● ●● ●● ●● The appliance must be set up on a firm, flat, level, non-slip and heat resistant base that has sufficient load bearing capacity. Select the place of location so that children cannot reach the hot surfaces of the appliance.
Only use whole coffee beans. ●● ●● ●● Select the grind by turning the grind adjustment collar to the desired setting. To grind coffee, set the switch to the ‘On’ position. When the desired amount of coffee has been ground, set the switch to the ‘Off’ position. Remove the coffee grounds container. Grinding coffee directly in the group handle ●● ●● ●● ●● ●● 6 Use the small or large group handle bracket. Hold the group handle between the group handle bracket.
●● The „P“ button will stay fully illuminated, while the button and buttons will soften in brightness. Notice: The programming mode can be aborted at any stage by pressing the „P“ button again. ●● ●● ●● Select either the or button to program the grind time for that selected button. The selected button will begin to flash, and the grinding will become activated. Coffee grounds will begin to fall into the group handle.
●● ●● Clean the coffee bean container and the coffee grounds container with warm water and a little bit of detergent. ●● If the coffee grinder is used frequently (every day), the burrs need to be cleaned every three weeks to ensure best performance of the coffee grinder. Regular cleaning helps the burrs achieve consistent grinding results, which is especially important when grinding coffee for espresso. ●● ●● ●● 8 ●● After that, dry both container well. Cleaning the burrs ●● the top burr.
●● Turn back the screws. structions points this out. The materials can be EN recycled in accordance with their markings. By recycling, making use of the materials or other forms of recycling old units you are making an important contribution to protecting our environment. Please ask your municipal administration about the responsible disposal sites. ●● Replace the burr. 2 year warranty Repeat the adjustment if it is not fine or coarse enough.
