Operating instructions
Coee Grinder CM 80
EN
34
Requirements for the installation location
For safe and awless operation of the unit, the place of loca-
tion must meet these prerequisites:
■ The unit must be set up on a rm, at, level, non-slip and
heat resistant base that has sufcient load bearing capacity.
■ Select the place of location so that children cannot reach
the hot surfaces of the unit.
■ The unit is not intended for installation in a wall or a built-in
cupboard.
■ Do not set up the unit in a hot, wet or moist environment.
■ The electric socket must be readily accessible so that the
power cord can be easily unplugged.
Electric connection
Follow these instructions about the electrical connection for
safe and awless operation of the unit:
■ Before connecting the unit, compare the connection infor-
mation (voltage and frequency) on the rating plate with
those of your electrical network. This information must
match to avoid damage to the unit. If in doubt, ask your
electrician.
■ The socket must be fused with at least a 10A circuit breaker.
■ Make sure that the power cord is not damaged. Do not
conduct it over hot surfaces or sharp edges.
■ The supply cord must not be pulled tight.
■ The electrical safety of the unit is only ensured if it
is connected to a properly installed protective con-
ductor system. Operation on a socket without a pro-
tective conductor is prohibited. If in doubt, have
the building installation checked by an electrician.
The manufacturer does not assume any responsibility for
damages caused by a missing or interrupted protective con-
ductor.