User's Manual Part 2

FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types AWS-2000T
(FCC ID: 2ACZKAWS2KT) AWS-2000P (FCC ID: 2ACZKAWS2KP) has also been tested against this
SAR limit. The highest reported SAR values for 1g body-worn Tissue is 0.55 W/kg for AWS-2000T,
0.07W/kg for AWS-2000P, respectively.
To maintain compliance with FCC RF exposure requirements, the use of accessories that do not satisfy
these requirements may not comply with FCC RF exposure requirements, and should be avoided .(So
you should use only with the supplied belt clip, thanks.)