Service Manual User guide

Insert two of the capscrews with washers
installed into opposite holes and torque
to 175 lbs. ft.
Using a 10" wrench, check to see if
the drive shaft will turn. Shaft will be
tight but should turn freely with a max-
imum of 5 to 10 lbs. torque.
If shaft will not turn as stated, dis-
assemble the pump and examine for
burrs or foreign material causing build-
up or interference in the parts.
Remove the cause and reassemble as
before.
When shaft turns properly, tighten the
remaining nuts and torque to 175 lbs.
ft. each.
REASSEMBLY
35.
36.
37.
38.
39.
80
FIGURE 139