Service Manual User guide

BRAKE ADJUSTMENT
SERVICE BRAKE
Note: Prior to any brake adjustment the forward-reverse linkage
must be adjusted as follows:
With the forward-reverse lever in neutral, adjust
linkage rod “A” so that “B” to “B1” and “C” to “C1”
are of equal length, with the forward-reverse valve
spool in its neutral position (linkage rod “D” may
have to be adjusted to reach alignment).
With the forward-reverse lever in forward, depress
brake pedal until all slop is taken up in the brake
linkage. At that point the spool in the forward-
reverse valve should be 1/8" out of the neutral
position. If not, adjust brake linkage compression
spring “E” to reach that point.
PARKING BRAKE
1.
2.
The spring-apply/hydraulic release brake requires
no adjustment.
On machines with mechanical brake calipers, adjust
both sides so the pads nearly touch the disc when
the lever is in the off position.
1.
2.
12
FIGURE 6