Service Manual Manual

STEERING PARTS

ASSEMBLY Install the constant velocity joint Install the spherical shell (bowl).

Install the guide bushing grease and shaft assembly. Grease all parts in contact with the

according to specification STB 1-306. axle housing and pivot, according to

specification STB 1-306.

Apply a bead of silicone to the

Install the cover. threaded area of the nut

Start turning the nut by hand

“CCW” to align the leading thread.

Tighten the nut with wrench accor- On the trunnion, install the outer oil

ding to specification STB 1-305. seal, greased according to

specification STB 1-306.

Note: Replace all oil seals after

disassembly.