User's Manual

MSP Modular Divider Valves
Page 2
L10102
Match lubricant fl ow to the exact needs of
each point.
Precise monitoring, positive feedback•
Simple to install and operate•
Modular design for total fl exibility•
The fl exible, modular MSP Divider Valve
For grease or oil systems up to 3,500 psi (241 bar)•
Lubricate up to 16 points per valve assembly•
Choice of SAE, NPSF or BSPP inlet/outlet connections•
O-Ring sealing prevents leaks, reduces maintenance•
Individual valve outputs vary by a maximum ratio of •
16:1
Built-in check valves prevent lube re-entry and help •
keep lines full
Stackable design simplifi es installation, adds fl exibility•
Available in carbon steel with corrosion-resistant •
plating. Contact Graco's factory regarding 316
stainless steel for corrosive applications
Match lubricant fl ow to the exact needs of
each point.
Each assembly includes: (1) valve sections with working
pistons (3 minimum), (2) subplates with outlet ports, (3) inlet
section, and (4) end sections.
Twin piston sections are ported to create separate outputs for
two lube points. Single sections combine the output from both
ends of the piston and send it to a single lube point.
Field-installable crossport or singling plates (5) may be used
to increase the fl ow to a single point or accommodate an odd
number of lube points.
A bypass section is available to eliminate a piston section or
provide for added lube points in the future.
NOTE: When bypass sections are used, the Divider Valve
assembly must have a minimum of 3 working sections in
addition to one or more bypass sections.
1
3
5
2
4