User's Manual

ORDERING INFORMATION
Graco endorses the SAE recommendation of ISO 18/14 (ISO 4406) oil cleanliness
for most bearing applications. Some high speed bearings may require cleaner oil.
Consult the bearing manufacturer for recommendation.
Ordering Example
5 section MXP divider valve with SAE ports and performance indicators
in each working outlet consisting of:
1-100 Twin Valve w/Cycle Pin Right Side
1-150 Single Valve Crossport Right Side
1-150 Single Valve Right Side Outlet
1-125 Twin Valve
1-Bypass Section
Order Code: MSP-SAE-P-5-100B-150SCR-150S-125T-BP
NOTES:
1. Capacity sections are specifi ed starting from inlet
section and must equal number of manifold sections
in subplate.
2. When capacity section is crossported, its outlet is
plugged and the output volume is diverted to next
section, farthest from inlet section.
3. Last capacity section, farthest from inlet, cannot be
crossported.
4. Single output capacity sections can be crossported
on one side only.
5. All crossporting is accomplished external using the
crossport kits listed on page 3.
6. When capacity section is singled, only one outlet
in its subplate can be used. Other outlet must be
plugged.
7. By-pass block cannot be supplied on a three section
assembly; all manifolded assemblies must have a
minimum of three working capacity sections.
8. Contact Graco for part numbers of stainless steel
components
9. Divider Systems should be limited to fi rst and second
stages only. Third staging is not recommended.
Refer to Trabon
®
bulletin L20101, L20105 and
L20115 for further information on system design.
All written and visual data contained in this document are based on the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice.
©2006-2009 Graco Inc. Form No. L10132 Rev. B 1/09 Printed in U.S.A. All other brand names or marks are used for identification purposes and are trademarks of their respective owners. All written and
visual data contained in this document are based on the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice.
Contact us today!
To receive product information or talk with a Graco representative,
call 800-533-9655 or visit us online at www.graco.com.
MXP - XXX - X - XX - XXX - X - XX
PORTING OPTIONS
SAE - STRAIGHT THREAD O-RING SEAL
NPT - NPSF PIPE THREAD
BSP - BSPP (ISO 1179)
ACCESSORY OPTIONS*
P - ASSEMBLY OF PERFORMANCE INDICATORS IN
ALL WORKING OUTLETS
*OMIT IF NOT REQUIRED
NUMBER OF SECTIONS
03 - THREE 07 - SEVEN
04 - FOUR 08 - EIGHT
05 - FIVE 09 - NINE
06 - SIX 10 - TEN
VALVE CAPACITY
BP - BYPASS 100 - .100 cu.in.
25 - .025 cu.in. 125 - .125 cu.in.
50 - .050 cu.in. 150 - .150 cu.in.
75 - .075 cu.in.
TYPE OF SECTION
T - TWIN STANDARD
S - SINGLE STANDARD - RH OUTLET
L - SINGLE STANDARD - LH OUTLET
B - TWIN W/CYCLE PIN RIGHT SIDE
C - SINGLE W/CYCLE PIN RIGHT SIDE - RH OUTLET
D - SINGLE W/CYCLE PIN RIGHT SIDE - LH OUTLET
CROSSPORTING OPTIONS
CR - RIGHT HAND SIDE
CL - LEFT HAND SIDE
CB - BOTH SIDES