User's Manual

Technology that Boosts Productivity

An easier way to take control

The intuitive user interface provides two display modes: “setup” for entering parameters and a “run” mode for operation. The user interface

monitors and tracks mix ratio, pressure, temperature and flow, and allows you to program maintenance schedules. It shuts down the system

if off-ratio conditions exist, and with its USB port, you can download historical spraying data.

Simplify the ratio checking process

The ratio checking process for epoxy intumescents is important

and documentation is often required. With the XM PFP’s controls,

it’s easy to make sure your material is on ratio.

1. Initiate ratio check process on the machine controls

2. Operator dispenses A and B materials into test beakers,

and weighs samples

3. Operator enters A and B weights on the control screen

4. Control screen provides “Pass” or “Fail” message, and

logs the results in the USB data.

The user interface also lets you keep track of your

fluid supply and spray parameters.

You can:

• Monitor the temperature of supply tanks,

fluid heaters and hose heat

• Set temperatures for A and B materials and hose.

• Set and monitor tank levels, turn automatic tank

filling on and off

Graco XHF

™

Spray Gun

• High-flow, high pressure gun

• Easily handles high-viscosity coatings, fiber

filled materials and epoxy intumescent materials

• Reduced clogging means more uptime

• Rated to 7250 psi (500 bar, 50 MPa)